Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide A to M
mpls ldp profile
Syntax
Release Information
Description
Options
Mode
1362
In Global Configuration mode:
mpls ldp [ interface ] profile [ profileName ]
no mpls ldp interface profile profileName
In Interface Configuration mode:
mpls ldp profile profileName
no mpls ldp profile
Command introduced before JunosE Release 7.1.0.
In Global Configuration mode, creates or modifies a configuration profile for LDP. Places
the CLI in LDP Configuration mode. The implicit default LDP profile specifies a value of
0 for hello hold-time; this value signifies 15 seconds for link hellos and 45 seconds for
targeted hello messages.
Any change to a profile affects all interfaces that use the profile; changes are effective
the next time the interface comes up.
In Interface Configuration mode, creates or enables LDP on the interface with the factory
default profile or the specified profile. The no version reverts to the default profile on the
interface.
In both modes, if you specify a profile not previously configured, it is created with the
factory default settings. If you do not specify a profile name, the factory default profile
is assumed. The no version deletes the specified profile.
interface—Keyword required for the no version in Global Configuration mode
profileName—Name of a profile to be created or modified (Global Configuration mode),
applied to an interface (Interface Configuration mode), or deleted (both modes); the
profile sets the values for the protocol parameters; until you modify the profile settings,
the values match those of the implicit default profile
Global Configuration, Interface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
