Extension Of Chip Select (Cs) Assertion Period - Renesas H8SX/1650 Hardware Manual

Section 6 Bus Controller (BSC)
6.6.6

Extension of Chip Select (CS) Assertion Period

Some external I/O devices require a setup time and hold time between address and CS signals and
strobe signals such as RD, LHWR, and LLWR.
Settings can be made in CSACR to insert cycles in which only the CS, AS, and address signals are
asserted before and after a basic bus space access cycle. Extension of the CS assertion period can
be set in area units. With the CS assertion extension period in write access, the data setup and hold
times are less stringent since the write data is output to the data bus.
Figure 6.22 shows an example of the timing when the CS assertion period is extended in basic bus
3-state access space.
Both extension cycle Th inserted before the basic bus cycle and extension cycle Tt inserted after
the basic bus cycle, or only one of these, can be specified for individual areas. Insertion or non-
insertion can be specified for the Th cycle with the upper eight bits (CSXH7 to CSXH0) in
CSACR, and for the Tt cycle with the lower eight bits (CSXT7 to CSXT0).
Rev.2.00 Jun. 28, 2007 Page 177 of 666
REJ09B0311-0200