Table of Contents
Advertisement
Section 5 Interrupt Controller
5.8.2
Instructions that Disable Interrupts
Instructions that disable interrupts immediately after execution are LDC, ANDC, ORC, and
XORC. After any of these instructions is executed, all interrupts including NMI are disabled and
the next instruction is always executed. When the I bit is set by one of these instructions, the new
value becomes valid two states after execution of the instruction ends.
5.8.3
Times when Interrupts are Disabled
There are times when interrupt acceptance is disabled by the interrupt controller.
The interrupt controller disables interrupt acceptance for a 3-state period after the CPU has
updated the mask level with an LDC, ANDC, ORC, or XORC instruction, and for a period of
writing to the registers of the interrupt controller.
5.8.4
Interrupts during Execution of EEPMOV Instruction
Interrupt operation differs between the EEPMOV.B and the EEPMOV.W instructions.
With the EEPMOV.B instruction, an interrupt request (including NMI) issued during the transfer
is not accepted until the transfer is completed.
With the EEPMOV.W instruction, if an interrupt request is issued during the transfer, interrupt
exception handling starts at the end of the individual transfer cycle. The PC value saved on the
stack in this case is the address of the next instruction. Therefore, if an interrupt is generated
during execution of an EEPMOV.W instruction, the following coding should be used.
L1:
EEPMOV.W
MOV.W R4,R4
BNE
L1
5.8.5
Interrupts during Execution of MOVMD and MOVSD Instructions
With the MOVMD or MOVSD instruction, if an interrupt request is issued during the transfer,
interrupt exception handling starts at the end of the individual transfer cycle. The PC value saved
on the stack in this case is the address of the MOVMD or MOVSD instruction. The transfer of the
remaining data is resumed after returning from the interrupt handling routine.
Rev.2.00 Jun. 28, 2007 Page 118 of 666
REJ09B0311-0200
Advertisement
Table of Contents
