Table of Contents
Advertisement
Section 7 Data Transfer Controller (DTC)
7.7.3
Chain Transfer when Counter = 0
By executing a second data transfer and performing re-setting of the first data transfer only when
the counter value is 0, it is possible to perform 256 or more repeat transfers.
An example is shown in which a 128-kbyte input buffer is configured. The input buffer is assumed
to have been set to start at lower address H'0000. Figure 7.16 shows the chain transfer when the
counter value is 0.
1. For the first transfer, set the normal transfer mode for input data. Set the fixed transfer source
address, CRA = H'0000 (65,536 times), CHNE = 1, CHNS = 1, and DISEL = 0.
2. Prepare the upper 8-bit addresses of the start addresses for 65,536-transfer units for the first
data transfer in a separate area (in ROM, etc.). For example, if the input buffer is configured at
addresses H'200000 to H'21FFFF, prepare H'21 and H'20.
3. For the second transfer, set repeat transfer mode (with the source side as the repeat area) for re-
setting the transfer destination address for the first data transfer. Use the upper eight bits of
DAR in the first transfer information area as the transfer destination. Set CHNE = DISEL = 0.
If the above input buffer is specified as H'200000 to H'21FFFF, set the transfer counter to 2.
4. Execute the first data transfer 65536 times by means of interrupts. When the transfer counter
for the first data transfer reaches 0, the second data transfer is started. Set the upper eight bits
of the transfer source address for the first data transfer to H'21. The lower 16 bits of the
transfer destination address of the first data transfer and the transfer counter are H'0000.
5. Next, execute the first data transfer the 65536 times specified for the first data transfer by
means of interrupts. When the transfer counter for the first data transfer reaches 0, the second
data transfer is started. Set the upper eight bits of the transfer source address for the first data
transfer to H'20. The lower 16 bits of the transfer destination address of the first data transfer
and the transfer counter are H'0000.
6. Steps 4 and 5 are repeated endlessly. As repeat mode is specified for the second data transfer,
no interrupt request is sent to the CPU.
Rev.2.00 Jun. 28, 2007 Page 248 of 666
REJ09B0311-0200
Advertisement
Table of Contents
