Section 15 D/A Converter
15.5
Usage Notes
15.5.1
Module Stop State Setting
Operation of the D/A converter can be disabled or enabled using the module stop control register.
The initial setting is for operation of the D/A converter to be halted. Register access is enabled by
clearing the module stop state. For details, see section 18, Power-Down States.
15.5.2
D/A Output Hold Function in Software Standby Mode
When this LSI enters software standby mode with D/A conversion enabled, the D/A outputs are
retained, and the analog power supply current is equal to as during D/A conversion. If the analog
power supply current needs to be reduced in software standby mode, clear the ADST, TRGS1, and
TRGS0 bits all to 0 to disable D/A conversion.
Rev.2.00 Jun. 28, 2007 Page 550 of 666
REJ09B0311-0200