Table of Contents
Advertisement
Section 4 Exception Handling
Table 4.3
Calculation Method of Exception Handling Vector Table Address
Exception Source
Reset, CPU address error
Other than above
[Legend]
VBR: Vector base register
Vector table address offset:
4.3
Reset
A reset has priority over any other exception. When the RES pin goes low, all processing halts and
this LSI enters the reset state. To ensure that this LSI is reset, hold the RES pin low for at least 20
ms with the STBY pin driven high when the power is turned on. When operation is in progress,
hold the RES pin low for at least 20 cycles.
The chip can also be reset by overflow of the watchdog timer. For details, see section 12,
Watchdog Timer (WDT).
A reset initializes the internal state of the CPU and the registers of the on-chip peripheral modules.
The interrupt control mode is 0 immediately after a reset.
4.3.1
Reset Exception Handling
When the RES pin goes high after being held low for the necessary time, this LSI starts reset
exception handling as follows:
1. The internal state of the CPU and the registers of the on-chip peripheral modules are
initialized, VBR is cleared to H'00000000, the T bit is cleared to 0 in EXR, and the I bits are
set to 1 in EXR and CCR.
2. The reset exception handling vector address is read and transferred to the PC, and program
execution starts from the address indicated by the PC.
Figures 4.1 and 4.2 show examples of the reset sequence.
Rev.2.00 Jun. 28, 2007 Page 72 of 666
REJ09B0311-0200
Calculation Method of Vector Table Address
Vector table address = (vector table address offset)
Vector table address = VBR + (vector table address offset)
See table 4.2.
Advertisement
Table of Contents
