Test Synchronization - Avaya S8700 Maintenance Manual

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance Commands

test synchronization

test synchronization [short | long] [repeat# | clear] [schedule]

The test synchronization command checks the timing synchronization source

and updates circuit packs with the correct synchronization parameters. The

Tone-Clocks, DS1s, and EIs are sent down-link messages to place them in the

correct synchronization configuration given the current on-line synchronization

The synchronization subsystem provides error-free digital communication

between the switch and other PBXs, COs, or customer premises equipment. The

subsystem is made up of the TDM bus clock, DS1 trunk circuit packs, and

maintenance and administration software resident.

Both long and short sequences run Test #417. If Stratum 3 synchronization is

administered, an additional non-destructive test (#649) is run by the long sequence.

The following screens show test results for the test synchronization command for

S8700 IP Connect and S8700 Multi-Connect configurations.

Issue 1 May 2002