Enabling Snmp Notifications For Radius; Display And Maintenance Commands For Radius - H3C SR8800-F Configuration Manual

Step
1. Enter system view.
2. Configure the device to
preferentially process
RADIUS authentication
requests.

Enabling SNMP notifications for RADIUS

When SNMP notifications are enabled for RADIUS, the SNMP agent supports the following
notifications generated by RADIUS:
•
RADIUS server unreachable notification—The RADIUS server cannot be reached. RADIUS
generates this notification if it does not receive a response to an accounting or authentication
request within the specified number of RADIUS request transmission attempts.
•
RADIUS server reachable notification—The RADIUS server can be reached. RADIUS
generates this notification for a previously blocked RADIUS server after the quiet timer expires.
•
Excessive authentication failures notification—The number of authentication failures
compared to the total number of authentication attempts exceeds the specified threshold.
For RADIUS SNMP notifications to be sent correctly, you must also configure SNMP on the device.
For more information about SNMP configuration, see Network Management and Monitoring
Configuration Guide.
To enable SNMP notifications for RADIUS:
Step
1. Enter system view.
2. Enable SNMP notifications
for RADIUS.

Display and maintenance commands for RADIUS

Execute display commands in any view and reset commands in user view.
Task
Display the RADIUS scheme
configuration.
Display RADIUS packet statistics.
Display information about buffered
RADIUS stop-accounting requests to
which no responses have been
received.
Clear RADIUS statistics.
Clear the buffered RADIUS
stop-accounting requests to which no
responses have been received.
Command
system-view
radius authentication-request
first
Command
system-view
snmp-agent trap enable radius
[ accounting-server-down |
accounting-server-up |
authentication-error-threshold |
authentication-server-down |
authentication-server-up ] *
Command
display radius scheme [ radius-scheme-name ]
display radius statistics
display stop-accounting-buffer { radius-scheme
radius-scheme-name | session-id session-id | time-range
start-time end-time | user-name user-name }
reset radius statistics
reset stop-accounting-buffer { radius-scheme
radius-scheme-name | session-id session-id | time-range
start-time end-time | user-name user-name }
41
Remarks
N/A
By default, the device processes
RADIUS requests in the sequence
that the requests are initiated.
Remarks
N/A
By default, all SNMP notifications
are disabled for RADIUS.