Troubleshooting; Router Failures; Power Status Leds Are Off; Run Led Is Off - H3C SR6602-X1 AC Installation Manual

Hide thumbs Also See for SR6602-X1 AC:
  • Faq (22 pages)
Table of Contents

Advertisement

Troubleshooting

NOTE:
The barcode stuck on the router chassis contains production and servicing information. Before you
return a faulty router for serving, provide the barcode information of the router to your local sales
agent.

Router failures

Power status LEDs are off

When the PWR1 and PWR2 LEDs are off, the power module of the router is faulty. For more
information about the PWR1 and PWR2 LEDs, see
To troubleshoot the problem:
Check whether a power module is plugged in a right slot.
1.
Check whether the power module is powered on normally. A green PWR LED indicates that the
2.
router is powered on properly.
If the cause cannot be located in the steps above and the problem persists, contact your local
3.
sales agent.

RUN LED is off

When the RUN LED of the router is off, it indicates that the router is faulty. For more information
about the RUN LED, see
To troubleshoot the problem, contact your local sales agent.

RUN LED fast flashes

Five minutes after the router is powered on, if the RUN LED still fast flashes at 8 Hz, it indicates that
the system software image fails to start or the router is faulty.
To troubleshoot the problem:
Check whether the terminal display is correct.
1.
Check whether the system software image file properties are correct in the BootWare menu.
2.
If the cause cannot be located in the steps above and the problem persists, contact your local
3.
sales agent.

ALM LED is steady on or flashes

If the ALM LED is steady on or flashes, it indicates that the router is faulty. The ALM LED may be on
in the following cases.
When the system is over-temperature. In this case, the system displays the following output:
%Dec
CPU temperature is greater than alarm upper limit in slot 0, index is 0.
To solve the problem, check the output (such as the system temperature, insufficient available power,
and PCB voltage alarms) on the serial terminal and the software management tool.
"Appendix B
7 11:17:01:436 2011 H3C DRVMSG/3/TEMP_ALARM:
"Appendix B
LEDs."
58
LEDs."

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sr6602-x seriesSr6602-x2 acSr6602-x1 dcSr6602-x2 dc

Table of Contents