RZ/A1L Group, RZ/A1LU Group, RZ/A1LC Group
7.4.4
Pin Interrupts
Pin interrupts are input from pins TINT121 to TINT0. Signals input on pins TINT121 to TINT0 are conveyed as
interrupt signals regardless of mode settings and pin function settings for the general-purpose I/O port pin.
Accordingly, if pin interrupts are to be used in port mode, set the pin as an input port pin. Alternatively, if an alternative
mode is selected, the alternative pin with an input function can only be used for pin interrupts. For the settings of general-
purpose I/O port pins, see section 41., Ports.
For the pin interrupts, high-level or rising-edge detection can be selected individually for each pin by the interrupt
configuration registers (ICDICFRn). For a description of the interrupt configuration registers (ICDICFRn), see the GIC
architecture specification.
R01UH0437EJ0600 Rev.6.00
Jan 29, 2021
7. Interrupt Controller
7-18