Configuration For Testing At Command With Evb Only; Figure 9: Configure Da16200 Evb For At Command - Uart To Ft2232H; Table 9: Default Gpio Pin Settings Of Uart And Spi; Table 10: Configure Da16200 Evb Switch For At Command - Uart To Ft2232H - Renesas DA16200 User Manual

UM-WI-056
DA16200 DA16600 FreeRTOS Getting Started Guide

Table 9: Default GPIO Pin Settings of UART and SPI

Interface
UART
SPI
MCU Wake-up on AT-CMD
4.7.1

Configuration for Testing AT Command with EVB Only

Both the DA16200 and DA16600 EVBs include an FT2232H which is used to test AT command over
the UART interface. Figure 9
command processing over the UART. This configuration connects UART1 of the DA16200
(GPIOA4/5) to the FT2232H.

Figure 9: Configure DA16200 EVB for AT Command - UART to FT2232H

Table 10: Configure DA16200 EVB Switch for AT Command - UART to FT2232H

SW1 SW2
All OFF All ON
Figure 10 and Table 11 show how to configure the DA16600 EVB for AT command processing over
the UART. This configuration connects UART2 of the DA16200 (GPIOC6/7) to the FT2232H.
User Manual
CFR0012
DA16200 SDK
GPIOA4 (UART1_TXD)
GPIOA5 (UART1_RXD)
GPIOA11 (MCU Wake-up)
and Table 10 shows how to configure the DA16200 EVB for AT
SW3 SW4
All OFF All ON
Revision 1.9
29 of 108
DA16600 SDK
GPIOC6 (UART2_TXD)
GPIOC7 (UART2_RXD)
GPIOA2 (SPI_CSB)
GPIOA3 (SPI_CLK)
GPIOA8 (SPI_MISO)
GPIOA9 (SPI_MOSI)
GPIOC6 (INT)
SW7 SW8
All ON LEFT
SW9 SW10
LEFT All ON
Apr. 05, 2024
© 2024 Renesas Electronics