Onu Port-Isolate Enable - H3C S7500E Series Command Reference Manual

Description
Use the onu-event { debug | log | trap } enable level command to specify the ONU to report log,
debugging, or trap information to the OLT.
Use the undo onu-event { debug | log | trap } command to restore the default.
By default, an ONU reports no information to the OLT.
Note that: because a large number of ONUs are attached to an OLT, enabling ONUs to report
information to the OLT may generate a large amount of traffic and thus cause congestion. Therefore,
you are recommended to select the reported information types as required.
Examples
# Configure the OLT attached to ONU 3/0/1:1 to report log information with severity levels higher than
errors.
<Sysname> system-view
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] onu-event log enable level ?
alerts
critical
debugging
emergencies
errors
information
notifications <=NOTICE level messages to OLT
warnings
[Sysname-Onu3/0/1:1] onu-event log enable level errors
# Disable the OLT attached to ONU 3/0/3:1 from reporting log information to the ONU.
<Sysname> system-view
[Sysname] interface onu 3/0/3:1
[Sysname-Onu3/0/3:1] undo onu-event log enable
Table 3-6 onu-event log enable level command output description
Field
emergencies
alerts
critical
errors
warnings
notifications
information
debugging

onu port-isolate enable

Syntax
onu port-isolate enable
<=ALERT level messages to OLT
<=CRIT level messages to OLT
<=DEBUG level messages to OLT
<=EMERG Level Switch to OLT
<=ERR level messages to OLT
<=INFO level messages to OLT
<=WARN level messages to OLT
Severity level
0
1
2
3
4
5
6
7
(severity=1)
(severity=2)
(severity=7)
(severity=0)
(severity=3)
(severity=6)
(severity=5)
(severity=4)
Indicating that the system is unavailable.
Errors that need to be corrected immediately.
Critical Information.
Errors.
Warning Information.
Normal information that needs to be noticed.
Normal prompt information that needs to be recorded.
Debugging information.
3-20
Remarks