Interface; Jumboframe Enable - H3C S7500E Series Command Reference Manual

Description
Use the group-member command to assign Ethernet interfaces to a port group.
Use the undo group-member command to remove Ethernet interfaces from the port group.
By default, there is no Ethernet interface in a manual port group.
When you assign multiple Ethernet interfaces to a specific manual port group with the group-member
interface-type interface-start-number to interface-type interface-end-number command, make sure
that:
All specified Ethernet interfaces are on the same card and of the same type.
The interface-end-number must be larger than the interface-start-number.
Examples
# Assign Ethernet interface GigabitEthernet 2/0/1 to port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member GigabitEthernet 2/0/1

interface

Syntax
interface interface-type interface-number
View
System view
Default Level
2: System level
Parameters
interface-type: Specifies and interface type.
interface-number: Specifies an interface number.
Description
Use the interface command to enter interface view.
Examples
# Enter GigabitEthernet 2/0/1 interface view.
<Sysname> system-view
[Sysname] interface gigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1]

jumboframe enable

Syntax
jumboframe enable [ value ]
undo jumboframe enable
View
Ethernet port view, port group view
Default Level
2: System level
1-23