Ppp Mp Max-Bind - H3C SR8800 Command Reference Manual

View
MP-group interface view
Default level
2: System level
Parameters
None
Description
Use the ppp mp fragment enable command to enable MP fragmentation.
Use the undo ppp mp fragment enable command disable MP fragmentation.
By default, MP fragmentation is enabled.
If the peer device does not support fragment reassembly, you must configure the undo ppp mp fragment
enable command on the local router to disable MP fragmentation, thus enabling the two devices to
communicate. After that, outgoing packets are not fragmented, but they still carry an MP sequence
number and fragment tag.
After you configure the undo ppp mp fragment enable command on an interface, the settings configured
with the ppp mp min-fragment command become invalid on the interface.
After configuring the ppp mp fragment enable command, you must use the shutdown and then undo
shutdown commands to re-enable all the bundled physical interfaces for the new setting to take effect.
Examples
# Disable MP fragmentation on interface MP-group 4/1/28.
<Sysname> system-view
[Sysname] interface Mp-group 4/1/28
[Sysname-Mp-group4/1/28] undo ppp mp fragment enable

ppp mp max-bind

Syntax
ppp mp max-bind max-bind-num
undo ppp mp max-bind
View
MP-group interface view
Default level
2: System level
Parameters
max-bind-num: Maximum number of links allowed in an MP bundle, in the range of 1 to 128.
Description
Use the ppp mp max-bind command to set the maximum number of links allowed in an MP bundle.
Use the undo ppp mp max-bind command to restore the default.
By default, the maximum number of links allowed in an MP bundle is 16. However, up to 12 links can be
brought up simultaneously in an MP bundle.
44