Configuring The Udp-Echo Test - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Configure the destination
port
Configure the source IP
address of a probe
request in a test operation
Configure common
optional parameters

1.6.8 Configuring the UDP-echo Test

Note:
You are not recommended to perform an NQA UDP test on ports from 1 to 1023
(known ports). Otherwise, the NQA test will fail or the corresponding services of this
port will be unavailable.
The UDP-echo test is used to test the roundtrip time of a UDP-echo packet from the
client to the specified server.
I. Configuration prerequisites
A UDP-echo test requires cooperation between the NQA server and the NQA client.
The UDP listening function needs to be configured on the NQA server before the
UDP-echo test.
To do...
destination port
port-number
source ip ip-address
Refer to
Optional Parameters
Common to an NQA Test
Group
Use the command...
Configuring
1-16
Chapter 1 NQA Configuration
Remarks
Required
By default, no destination
port number is configured
for a test operation.
The destination port
number must be
consistent with port
number of the listening
service configured on the
NQA server.
Optional
By default, no source IP
address is specified.
The source IP address
must be that of an
interface on the device
and the interface must be
up. Otherwise, the test will
fail.
Optional