Step
1.
Enter system view.
2.
Create an NQA operation
and enter NQA operation
view.
3.
Specify the TCP type and
enter its view.
4.
Specify the destination
address of TCP packets.
5.
Specify the destination port of
TCP packets.
6.
(Optional.) Specify the source
IP address of TCP packets.
Configuring the UDP echo operation
The UDP echo operation measures the round-trip time between the client and a UDP port on the NQA
server.
The UDP echo operation requires both the NQA server and the NQA client. Before you perform a UDP
echo operation, configure a UDP listening service on the NQA server. For more information about the
UDP listening service configuration, see
To configure the UDP echo operation:
Step
1.
Enter system view.
2.
Create an NQA operation
and enter NQA operation
view.
3.
Specify the UDP echo type
and enter its view.
4.
Specify the destination
address of UDP packets.
Command
system-view
nqa entry admin-name
operation-tag
type tcp
destination ip ip-address
destination port port-number
source ip ip-address
"Configuring the NQA
Command
system-view
nqa entry admin-name
operation-tag
type udp-echo
destination ip ip-address
19
Remarks
N/A
By default, no NQA operation is
created.
N/A
By default, no destination IP address is
specified.
The destination address must be the
same as the IP address of the listening
service configured on the NQA server.
By default, no destination port number
is configured.
The destination port number must be
the same as the port number of the
listening service on the NQA server.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
TCP packets can be sent out.
server."
Remarks
N/A
By default, no NQA operation is
created.
N/A
By default, no destination IP address
is specified.
The destination address must be the
same as the IP address of the listening
service configured on the NQA
server.