Pppoeoa Server Configuration Example - H3C SR6600 Configuration Manual

PPPoEoA Server Configuration Example

Network requirements
As shown in Figure
communicates with the router through DSLAM. The requirements are:
The IP addresses of the VT interface of router C are 202.38.160.1 and 202.38.161.1.
The VPI/VCI addresses of two PVCs connecting router C with DSLAM are 0/0/60 and 0/0/61, pointing to
ADSL Router A and ADSL Router B respectively.
Both the WAN port of router C and the DSL interface of ADSL Router adopt PPPoEoA. Each host within
the two Ethernets uses pre-installed PPPoE Client program to make interactive PAP authentication with
routers, and obtains an IP address from the router.
Figure 1-6 Network diagram for PPPoEoA server configuration
Host A
Host B
Host C
Host D
Configuration procedure
Configure Router C:
# Configure the users in the domain to use the PPP authentication scheme, and create a local IP
address pool.
<RouterC> system-view
[RouterC] local-user user1
[RouterC-luser-user1] service-type ppp
[RouterC-luser-user1] password simple pwd1
[RouterC-luser-user1] quit
[RouterC] local-user user2
[RouterC-luser-user2] service-type ppp
[RouterC-luser-user2] password simple pwd2
[RouterC-luser-user2] quit
[RouterC]domain system
[RouterC-isp-system] authentication ppp local
[RouterC-isp-system] ip pool 1 202.38.162.1 202.38.162.100
[RouterC-isp-system] quit
# Create the VT interface to encapsulate the PPP protocol and configure PAP authentication
parameters.
[RouterC] interface virtual-template 10
[RouterC-Virtual-Template10] ip address 202.38.160.1 255.255.255.0
1-6, each host inside Ethernet dials into ATM network through an ADSL router, and
ADSL Router
Router A
To Router A:0/0/60
To Router B:0/0/61
DSLAM
Router B
ADSL Router
ATM1/0/1.1
VPI/VCI:
Router C
VT10
202.38.160.1/24
VT11
202.38.161.1/24
1-22