Nqa Server Udp-Echo - H3C SR6600 Command Reference Manual

Syntax
nqa server tcp-connect ip-address port-number
undo nqa server tcp-connect ip-address port-number
Views
System view
Default command level
2: System level
Parameters
ip-address: Specifies the IP address for the TCP connect listening service.
port-number: Specifies the port number for the TCP connect listening service, in the range of 1 to 50000.
Usage guidelines
Configure the command on the NQA server for the TCP operation only.
The IP address and port number must be consistent with those on the NQA client and must be different
from those of an existing TCP listening service.
The IP address must be that of an interface on the NQA server. Otherwise, the configuration is invalid.
Examples
# Configure a TCP listening service to enable the NQA server to listen and respond on the IP address
169.254.10.2 and port 9000.
<Sysname> system-view
[Sysname] nqa server tcp-connect 169.254.10.2 9000
Related commands
nqa server enable
•
• display nqa server status

nqa server udp-echo

Use nqa server udp-echo to configure a UDP echo listening service to enable the NQA server to listen
and respond on the specified IP address and port.
Use undo nqa server udp-echo to remove the UDP listening service created.
Syntax
nqa server udp-echo ip-address port-number
undo nqa server udp-echo ip-address port-number
Views
System view
Default command level
2: System level
Parameters
ip-address: Specifies the IP address for the UDP echo listening service.
port-number: Specifies the port number for the UDP listening service, in the range of 1 to 50000.
67