General Information - New Holland T8010 Manual

Template Name: OML_2_col
Template Date: 2001_03_06
Cleaning
Clean all metal parts except bearings, in mineral
spirits or by steam cleaning. Do not use caustic
soda for steam cleaning. After cleaning, dry and
put o il o n all p ar ts. Cle an oi l pas s age s wi th
compressed air.
Inspection
Check all parts when the parts are disassembled.
Replace all parts that have excessive wear or are
d a m a g e d . S m a l l s c o r i n g o r g r o ove s c a n b e
removed with a hone or crocus cloth. Complete
visual inspection for indications of wear, pitting and
the replacement of par ts necessary will prevent
early failures.
Bearings
Clean bearings with a good clean solvent and
permit to air dry. DO NOT DRY BEARINGS WITH
COMPRESSED AIR. Check bearings for smooth
easy action. If the bearing has a loose fit or rough
action, the bearing must be replaced.
Needle Bearings
Before you press needle bearings into a bore,
always remove any metal protrusions in the bore or
the edge of the bore. Before you press bearings
into position, put petroleum jelly on the inside and
outside diameter of the bearing.
Rac 0-00000
Section 00 - General Information - Chapter 2

GENERAL INFORMATION

00-2-5
Gears
Check all gears for excessive wear or damage.
Replace gears as necessary.
Oil Seals, O-rings and Gaskets
Always install new oil seals, O-rings and gaskets.
Put petroleum jelly on seals and O-rings.
Shafts
Check all shafts for excessive wear or damage.
Check the bearing and oil seal surfaces on the
shafts for excessive wear or damage. Replace
shafts as necessary.
Service Parts
Always install genuine New Holland service parts.
When ordering refer to the Parts Catalog for the
correct part number of the genuine New Holland
replacement items. Failures due to the use of other
than genuine New Holland replacement parts are
not covered by warranty.
Lubrication
Use only the oils and lubrication specified in the
Operator's or Repair Manual. Failures due to the
use of non specified oils and lubricants are not
covered by warranty.