New Holland T8010 Manual page 641

Hide thumbs Also See for T8010:

Table of Contents

For All Axles

Determine shim pack requirements as follows:

1. Remove threaded rod, ram, and spacer.

2. Do not rotate the axle.

3. Measure the distance from the bearing to the far

side of the bearing snap ring groove.

4. Select a shim pack whose total height when

combined with the thrust ring and retaining ring is

equal to the distance obtained in step 3.

5. Install the shim pack, thrust ring, and retaining

ring on the axle. Be sure the thickest shim is next

to the bearing.

6. Be sure the retaining ring is fully seated in the

Section 27 - Rear Axle - Chapter 1

Install the pushing bridge and a 30-ton ram onto the

axle assembly. Back press the 4-inch axle 75 650 N

(17,000 lbs.). Back press the 4.5-inch axle 97 900 N

(22,000 lbs.). Check to assure the snap ring is tight in

the groove and will not rotate.

NOTE: It may be necessary to make calculations to

determine the force to use with your ram. See How

To Determine Ram Pressure on page 22.

3. AXLE HOUSING

Chapters

Table of Contents

T8020 T8030 T8040