New Holland T8010 Manual page 965

Hide thumbs Also See for T8010:

Table of Contents

Steer the axle until the string (1) hangs vertically and

bisects the dowel hole (2) and threaded hole (3) in

the drag link. The axle will then be "Dead Centered".

NOTE: The string must hang freely between the

drag link and weight support bracket.

NOTE: If this step is not performed correctly, all

other measurements and adjustments will be

Remove two nuts and washers from the rim mounting

bolts from the location shown. Use an appropriate

solvent to clean the nuts and washers.

Measure the combined thickness of the nut and

washer. The stack height must be within 0.05 mm

(0.002 in.) of each other. If they are not within

specification, obtain new hardware and ver ify

combined thickness.

Section 41 - Steering - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040