STEP 197
Install a new friction plate.
NOTE: Dip all friction plates in clean transmission
fluid.
STEP 198
Install the remaining 10 separator plates and 10
friction plates, alternating the plates.
STEP 199
Install the backing plate. The flat side of the plate
must face down.
Section 21 - Transmission, Drivelines - Chapter 4
A11577
A11578
A11579
21-4-57
STEP 200
Install the snap ring.
STEP 201
Install the needle thrust bearing and the two bearing
thrust washers. The needle thrust bearing must be
between the two bearing thrust washers.
A11580
A11581