New Holland T8010 Manual page 571

Hide thumbs Also See for T8010:

Table of Contents

Install new wheel studs, if necessary.

TWELVE BOLT AXLE ONLY. Thoroughly clean the

dust seal seating area.

Clean the bolt holes in the steering knuckle with a tap

and Loctite® Safety Solvent.

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

Place a shop towel in the center of the steering

knuckle (1) and clean the bolt holes with compressed

air. Remove the towel.

Thoroughly clean the steering knuckle.

Install the bearing and LIGHTLY coat the bearing

with a light multipurpose oil.

Chapters

Table of Contents

T8020 T8030 T8040