New Holland T8010 Manual page 551

STEP 11
1
Swivel the steering knuckle to gain access to the
planetary input sun gear shaft. Use 380000805
Retaining Ring Offset Pliers to remove the snap ring
(1). Remove the washer (2) from the planetary input
sun gear shaft.
NOTE: Axle shaft removed
purpose.
STEP 12
Use two prybars at the steering knuckle to remove
the planetary gear shaft from the yoke retaining ring.
NOTE: Remove the thrust washer on the planetary
gear shaft for tractors equipped with ten bolt hubs.
Section 25 - Four-Wheel Drive Front Axle - Chapter 10
RD02J001
2
RD02J002
for photographic
RR98K092
STEP 13
Remove the eight retaining plate bolts. Discard the
bolts.
NOTE: NEW BOLTS need to be installed during
reassembly.
STEP 14
Remove the retaining plate and shims. Slide the
planetary ring gear assembly off the splines of the
steering knuckle. The outer planetary hub bearing
will be removed with the planetary ring gear hub.
NOTE: Twelve bolt planetary hub assembly shown.
Remove the thrust washer used on the ten bolt
planetary hub assembly, after the removal of the
shims.
25-10-6
RR98K093
RR98K094