STEP 131
Slowly draw seal into the hub.
STEP 132
If seal is not being drawn into the bore straight, tap
on the installation tool to "square" the seal in the
bore. Once seal is seated in the bore, remove the
installation tools.
STEP 133
Inspect the seal (1) to make sure it is fully seated in
the bore. Remove the hub from the vise.
Section 25 - Four-Wheel Drive Front Axle - Chapter 10
RD05M026
RD05M027
1
RD02M029
25-10-36
STEP 134
Bolt the seal installation adapter over the end of the
steering knuckle.
STEP 135
Place the installation hub on the wheel hub.
STEP 136
Bolt the spanner plate (1) to the spacers (2).
RD05M030
RD05M031
1
2
RD05M032