New Holland T8010 Manual page 309

STEP 220
1
2
3
Place the 5 inch long piece of PVC pipe (1) over the
shaft (2). Make sure the pipe is centered at the
bottom of the gear/can weldment (3).
STEP 221
2
1
Install retainer ring (1) in lower ring groove, as
shown, for heavy duty twelve-bolt axle. For ten-bolt
axle, install the retainer ring in the upper ring grove
(2) (not shown).
STEP 222
1
2
Lubricate a new O-ring (1) with petroleum jelly and
install in the seal ring groove (2).
Section 21 - Transmission, Drivelines - Chapter 6
RD05K087
RD05K068
RD05K030
21-6-56
STEP 223
Lubricate a new seal with petroleum jelly and install.
Use care not to overstretch the seal.
STEP 224
Lubr i cate a new O- r i ng (1) and seal (2) with
petroleum jelly and install in the piston seal grove (3).
DO NOT overstretch the seal during installation.
STEP 225
Hand press the piston onto the hub to "size" the seal
rings. Remove the piston and set aside.
RD05K029
RD05K058
RD05M019