New Holland T8010 Manual page 376

Hide thumbs Also See for T8010:

Table of Contents

Install a new O-ring lubricated with petroleum jelly on

the differential lock supply tube.

Install the bearing cup into the housing until seated

against the housing.

Install the smaller thrust washer into the differential

housing so the washer tabs enter the cavities in the

Section 21 - Transmission, Drivelines - Chapter 8

Install the standard side gear in the housing so the

gear teeth face away from the thrust washer.

Apply petroleum jelly to the four thrust washers.

Install two washers for the long pinion shaft so the

tabs (1) enter the cavities (2) in the housing. The long

shaft does not use locking bolts.

Apply petroleum jelly to the inside of the four pinion

gears. Install 28 needle bearings in each gear.

Chapters

Table of Contents

T8020 T8030 T8040