New Holland T8010 Manual page 926

STEP 4
R e m o v e t h e e l e c t r o n i c d r a f t c o n t r o l ( E D C )
components as follows:
1. Disconnect the EDC pin electrical connector
from the top of the EDC tube (3).
2. Remove the hex head bolt (9) through the
bracket at the top of the EDC tube.
3. Remove the three bolts from the cover over the
electronic draft control (EDC) pin and the EDC
tube in the rear of the draft arm.
4. Carefully remove the EDC pin, cover, and tube
as a complete subassembly.
IMPORTANT: Be prepared for the sudden drop of
the draft arm as the pin is removed.
NOTE: Removal of the tube bracket (13) from the
axle carrier is not required.
STEP 5
Remove the EDC pin from the other side of the rear
frame housing also.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
26-35
27-7
35-11-5
STEP 6
2
14. RH LIFT LINK ASSY
15. LH LIFT LINK ASSY
16. LIFT LINK PIN
17. LOCKING FLAG PLATE
18. HEX HEAD BOLT
Once the EDC pins have been removed, pull and
remove the draft arms.
STEP 7
1
2
Remove the hex head bolt, washer, spacer and nut
(1) from the locking plate (2) where the vertical lifting
link (3) is attached to the rock shaft. Properly support
the lift link (3) and remove the flag/pin assembly (2).
6 5
4
3
1
11
9
10
8
7
DRAFT ARMS
19. NUT
20. FLAG PIN ASSEMBLY
21. SPACER
22. WASHER
23. NUT
24. BOLT
INF5299L
1
3
RI03G003