New Holland T8010 Manual page 324

Hide thumbs Also See for T8010:

Table of Contents

Tilt the range input shaft over to the side and install

the range transmission countershaft.

Apply petroleum jelly to the seal r ings on the

countershaft low range driven gear. Install the front

bearing support cover. Tap the support cover down

over the dowel pins in the range housing.

Install and tighten the support cover bolts to a torque

of 90 to 107 Nm (66 to 79 lb. ft.).

Section 21 - Transmission, Drivelines - Chapter 6

Place the original shims over the end of the range

transmission countershaft.

Install the countershaft front bearing cage. Install the

mounting bolts to a torque of 54 to 61 Nm (40 to 45

Apply petroleum jelly to the four seal rings on the

front end of the input shaft. Place the original shims

over the range input shaft.

Chapters

Table of Contents

T8020 T8030 T8040