New Holland T8010 Manual page 181

Hide thumbs Also See for T8010:

Table of Contents

Install the first piston-return Belleville washer. The

concave side of the washer must be facing down.

Install the lube management ring.

Install the remaining eight Belleville washers.

Section 21 - Transmission, Drivelines - Chapter 4

1. Install the snap ring on the shaft.

2. Install the compression sleeve CAS1903-3 with

the notch over the shaft.

3. Use a hydraulic press to compress the Belleville

4. Install the snap ring in the groove.

Install the needle thrust bearing and the two bearing

thrust washers. The needle thrust bearing must be

between the two bearing thrust washers.

Install a new seal ring on the creeper driven gear.

Chapters

Table of Contents

T8020 T8030 T8040