STEP 259
Continue to lower the assembly into the housing until
it is seated in the bore.
NOTE: Make sure that the alignment pin located at
the end of the output shaft mounting flange is aligned
with the alignment hole as shown in the following
step.
STEP 260
1
Once the alignment pin (1) is properly aligned, install
the six mounting bolts. Tighten bolts to a torque of
101 to 113 Nm (78 to 84 lb. ft.). Install the FWD lube
fitting (2) if removed.
Section 21 - Transmission, Drivelines - Chapter 6
RD05K017
2
RD05K063
21-6-64
STEP 261
Install the FWD lube tube at the shaft end and to
fitting in top of range casting.
STEP 262
Install a new O-ring on each end of the jumper tube,
lubricate with petroleum jelly and install. Repeat for
the opposite side.
A22327
16S35