STEP 90
1. MARK ON FACE OF
CARRIER
Make an appropriate mark with scratch awl, prick
punch, etc., on the front end of the carrier. Make a
similar mark on the same end of the shaft. Make sure
that these marks are aligned. These marks will be
use d to alig n the car r ier o n the sha ft dur in g
assembly.
NOTE: If a new part replaces an old part, make a
mark on the new part that is in the same position as
the mark for the old part.
Section 21 - Transmission, Drivelines - Chapter 4
1
2
468L72
2. MARK ON FRONT END OF
SHAFT
STEP 91
Press the splined front end of the shaft so that the
shaft moves through the clutch plate carrier.
21-4-29
T95333