New Holland T8010 Manual page 234

Hide thumbs Also See for T8010:

Table of Contents

1. 5TH CLUTCH PLATES

Check 5th gear clutch piston operation as follows:

1. Install the tip of the air gun into the oil hole in the

first groove from the rear of the output shaft. The

air pressure will move the clutch plates in the 5th

gear clutch.

2. Replace the seals on the clutch piston if the

clutch plates do not move.

1. 1ST CLUTCH PLATES

Check 1st gear clutch piston operation as follows:

1. Install the tip of the air gun into the oil hole in the

second groove from the rear of the output shaft.

The air pressure will move the clutch plates in the

1st gear clutch.

2. Replace the seals on the clutch piston if the

clutch plates do not move.

Section 21 - Transmission, Drivelines - Chapter 4

1. 3RD CLUTCH PLATES

Check 3rd gear clutch piston operation as follows:

1. Install the tip of the air gun into the oil hole in the

third groove from the rear of the output shaft.

The air pressure will move the clutch plates in the

3rd gear clutch.

2. Replace the seal rings on the clutch piston if the

clutch plates do not move.

Chapters

Table of Contents

T8020 T8030 T8040