New Holland T8010 Manual page 228

Hide thumbs Also See for T8010:

Table of Contents

Install the compression sleeve CAS1903-5 over the

NOTE: The large OD end of the sleeve must be up.

Install snap ring as follows:

1. Insert a tubular pressing tool that is smaller in

diameter than the larger ID of the compression

tool, but not so small that it goes through the hole

in the compression tool.

2. Use a hydraulic press to press the carrier snap

ring into the groove.

3. Verify that the snap ring is seated properly in the

Section 21 - Transmission, Drivelines - Chapter 4

Use a screwdriver to install the snap ring that was

installed on top of the gear (Step 219), into the inside

groove in the carrier. Air check the clutch using the

procedure in Step 252.

Apply petroleum jelly to the teflon rings and install the

reverse clutch piston into the carrier with the flat side

facing down.

Chapters

Table of Contents

T8020 T8030 T8040