New Holland T8010 Manual page 586

Hide thumbs Also See for T8010:

Table of Contents

Install the upper thrust washers on the planetary

Install the planetary gear pin and the retaining ring.

Repeat the proceeding procedures to install the rest

of the planetary gears in the planetary hub.

Clean the planetary hub cover flange surface. Apply

a bead of Loctite® 515 Gasket Eliminator to the

planetary hub cover.

Section 25 - Four-Wheel Drive Front Axle - Chapter 10

Properly support the planetary hub cover and install

on the hub. Install the three Allen head bolts. Tighten

the bolts to a torque of 10 to 16 Nm (7 to 12 lb. ft.).

Install the axle drain plug. Tighten the plug to a

torque of 38 to 41 Nm (28 to 30 lb. ft.).

Remove the axle fill plug located on the front of the

axle housing. Add Case 135 H EP Gear Lubricant

until the oil level is even with the bottom of the hole.

After a few minutes, recheck the oil level. Install the

fill plug. Tighten the plug to a torque of 38 to 41 Nm

(28 to 30 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040