New Holland T8010 Manual page 635

STEP 34
Lubricate the needle bearings with petroleum jelly to
keep them in place and install the bearings on one
side. Turn the planet gear around and install the
thrust ring. Install the remaining needle bearings
lubricated with petroleum jelly.
Models 215 and 245 will have two rows of 29
bearings in each gear.
Model 275 and 305 will have two rows of 33 bearings
in each gear.
STEP 35
Install the thrust washer on both sides of the planet
gear.
Section 27 - Rear Axle - Chapter 1
STEP 36
RD98C0194
Put the planet gear assembly into position in the gear
carrier. Make sure that the assemblies are installed in
their original locations.
NOTE: Three-gear planetary shown.
STEP 37
Align the holes in the bearing shaft with the roll pin
hole in the planetary gear carrier.
RDC195
27-1-16
T98003
T98002