STEP 181
1. PLUG
1. Install the plug (2) flush to the surface, as shown.
2. Make sure that all the oil passages in the shaft
are clean and open.
STEP 182
Hit the clutch carrier against a wood block to remove
the clutch pistons.
Section 21 - Transmission, Drivelines - Chapter 4
1
1
DBR02
T95479
21-4-53
STEP 183
Replace the teflon ring and O-ring on the piston and
carrier as follows:
1. Install the O-ring in the groove.
2. Install the teflon ring over the O-ring.
STEP 184
Install the snap ring into the third groove in the shaft,
down from the rear end of the shaft.
T95337
40-35
T95497