Installation
STEP 14
Apply petroleum jelly to new O-rings and install the
O-rings onto the valve mounting plate.
STEP 15
3
1
1. INLET
2. LUB INLET
3. PTO PWM SOLENOID
1. Position the valve onto the mounting plate. Install
the mounting bolts (5) and tighten to a torque of
41 to 46 Nm (30 to 34 lb. ft.).
2. Connect the wire harness connectors to the diff
lock solenoid (4) and PTO solenoid (3).
Section 35 - Hydraulic Systems, 3PT - Chapter 3
RI02E059
2
5
4
35-3-9
4. DIFF LOCK SOLENOID
5. MOUNTING BOLT
3. Connect and tighten the tube to the lube inlet
fitting (2).
4. Connect and tighten the tube to the valve inlet
fitting (1).
RI02D105