STEP 210
1. Install the compression sleeve CAS1903-3 with
the notch over the shaft.
2. Use a hydraulic press to press the sleeves down.
The snap ring will be pushed into position in the
groove.
3. Verify that the snap ring is seated properly in the
groove.
STEP 211
Install a separator plate.
NOTE: 1st and 3rd clutch does not use a reaction
plate (thicker than separator plate).
Section 21 - Transmission, Drivelines - Chapter 4
A11596
A11598
21-4-60
STEP 212
Install a new friction plate.
NOTE: Dip all friction plates in clean transmission
fluid.
STEP 213
Install the remaining 8 separator plates and 8 friction
plates, alternating the plates.
STEP 214
Install the backing plate.
NOTE: The flat side of the plate must face down.
A11599
A11600
A11590