New Holland T8010 Manual page 252

Hide thumbs Also See for T8010:

Table of Contents

Connect the wire harness to the MFD and PTO

Connect the draft pin connector (1 - LH and RH side)

and the transmission sump temperature sender

connector (2) to the wire harness.

Connect the hitch position sensor to the wire

Section 21 - Transmission, Drivelines - Chapter 5

Install the hitch position sensor cover and tighten the

If not already done, install all removed drain plugs in

the transmission.

Remove the rear handler, front splitting stand and

jack stands.

Chapters

Table of Contents

T8020 T8030 T8040