New Holland T8010 Manual page 249

Hide thumbs Also See for T8010:

Table of Contents

Disconnect the remote auxiliary controller (1) from

the wire harness. Move the remaining controllers and

wire harness (2) forward until the harness is on the

front side of the rear housing/range housing seam.

Tag and remove the hydraulic lines from the remote

valve. Cap all lines and fittings.

Remove the cover from the RH side of the range

transmission. Move the snap ring out of the groove

and forward on the shaft.

Section 21 - Transmission, Drivelines - Chapter 5

Remove the top bolts.

Remove the five bolts on each side of the housing.

Install alignment dowels on each side.

NOTE: Two bolts on the bottom are removed from the rear.

Separate the rear housing from the range housing. As the

rear housing is moved rearward, move the snap ring and

gear forward on the shaft. There is also a spacer between

the snap ring and gear. Be sure to capture the snap ring,

spacer and gear before they reach the end of the shaft.

NOTE: Be sure that the PTO input shaft (1) stays

with the rear housing.

Chapters

Table of Contents

T8020 T8030 T8040