New Holland T8010 Manual page 199

STEP 123
Install the lube management ring.
STEP 124
Install the remaining Belleville washers as follows:
1. Install the second Belleville washer. The concave
side of the washer must be facing up.
Install the remaining seven Belleville washers,
alternating the position of the washers until the last
washer with the concave side is facing down.
STEP 125
Install the snap ring over the shaft.
Section 21 - Transmission, Drivelines - Chapter 4
RD05M005
RD05M006
A11540a
21-4-38
STEP 126
Install the Belleville washer compression sleeve
CAS1903-5 over the shaft and on top of the snap
ring. The smaller OD side of the sleeve must be
facing up.
STEP 127
Install snap ring as follows:
1. Install the compression sleeve CAS1903-3 with
the notch over the shaft.
2. Use a hydraulic press to press the sleeve down.
The snap ring will be pushed into position in the
groove with the pin between the snap ring ends.
3. Verify that the snap ring is seated properly in the
groove.
A11541a
A11542