New Holland T8010 Manual page 50

STEP 67
Install the ground wire (1) and the clamp (2).
STEP 68
Install the three alternator wires.
STEP 69
1
2
Connect the A / C compressor clutch (1) and the high
pressure switch (2) connectors.
Section 10 - Engine - Chapter 1
1
2
RD05N108
RD05N107
RD05N106
STEP 70
2
Install the heater out (1) and in (2) hoses.
STEP 71
Install the starter cables.
STEP 72
1
2
Install the turbo to charge-air cooler pipe assembly
(1). Install the clamp (2).
NOTE: Do not tighten clamp (2) until the cooling
module has been installed. This will allow alignment
of the pipe with the charge-air cooler connector.
10-1-15
1
RD05N105
RD05N104
RD05N103