Disassembly - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Disassembly

Place the hitch valve on a clean work surface.

Remove the solenoid coils from the valve.

Remove the raise solenoid core, control pin and pilot

spool. Discard both O-rings. Inspect for heavy wear

or damage. Replace the valve assembly if necessary.

Repeat for the lower solenoid core.

Section 35 - Hydraulic Systems, 3PT - Chapter 10

Remove the raise spool. Discard the O-ring. Inspect

for heavy wear or damage. Replace the valve

assembly if necessary.

Remove the load check spring and ball. Discard the

If not removed, remove the tee fitting from the load

sense check port. Use a 3/16 Allen wrench and

remove the load sense check.

Table of Contents

T8020 T8030 T8040