New Holland T8010 Manual page 507

STEP 55
Install the bearing caps and cap bolts. Tighten the
bolts to a torque of 244 to 271 Nm (180 to 200 lb. ft.)
(Use a 24 mm socket).
STEP 56
Position Gauge Block FNH 00404 or 380001135
under Tube FNH 00406 or 380001137. Use a feeler
gauge and measure the distance between the tube
and the block. This dimension is the shim thickness
needed, provided the pinion shaft has not "+" or "-"
marking n the button end.
Section 25 - Four-Wheel Drive Front Axle - Chapter 8
T98522
T98523
STEP 57
If the pinion shaft has a "+" marking, subtract the
amount shown from the measurement taken in Step
65. The remainder is your shim pack thickness.
If the pinion shaft has a "-' marking, add the amount
shown to the measurement taken in Step 65. The
sum will be your shim pack thickness.
NOTE: The "+" and "-" markings on the pinion shaft
are given in thousandths of an inch. Shims are
available in thicknesses of 0.076 mm (0.003 inch),
0.127 mm (0.005 inch), 0.25 mm (0.010 inch).
Acceptable tolerance is 0.050 mm (+/-0.002 inch) of
number etched
calculation).
STEP 58
Remove the depth setting tool FNH 00400 or
380001109 from the carrier housing.
STEP 59
If necessary to adjust pinion position, remove the
inner bearing cup.
25-8-18
on pinion shaft (total shim
T98489