New Holland T8010 Manual page 510

STEP 67
Remove nut and end yoke. Apply Loctite 515 to the
housing face and to the outer diameter of oil seal.
STEP 68
Us e th e P i n io n S e a l I ns t al l e r FNH 0 0 41 9 o r
380001111 to install a new pinion shaft oil seal.
Install the seal with the lip towards the pinion shaft.
Section 25 - Four-Wheel Drive Front Axle - Chapter 8
RR98K043
RR98K044
STEP 69
Use tool CAS-2596 or 380001108 and install a new
dust shield (slinger) on the input yoke. Make sure
sealing surface for oil seal is in good condition.
STEP 70
Tighten the pinion nut to a torque of 326 to 406 Nm
(240 to 300 lb. ft.) (1-5/16 inch socket).
25-8-21
T98534
T98530