New Holland T8010 Manual page 156

Hide thumbs Also See for T8010:

Table of Contents

Position the front splitting stand 17-526A (1) and

attach the adapter plates (2) on both sides.

Position the rear housing handler 17-527 (3) and

adjust it to suppor t the rear frame and range

transmission without lifting up on them.

Be sure that the transmission is as level as possible

and that the front wheels are as straight as possible.

This will aid in shaft alignment on assembly.

NOTE: The exhaust stack does not have to be

removed for this split, but removal does simplify the

NOTE: Rear wheels removed for photographic

NOTE: Tag and identify all lines before removing

them throughout this procedure.

Section 21 - Transmission, Drivelines - Chapter 3

Disconnec t the wir e har nes s fr om the speed

powershift valve solenoids.

Remove the clamp bar (1) over the hydraulic lines on

top of the speed transmission. Tag and remove the

If equipped, disconnect the true ground speed radar

from the wire harness and remove the radar and

mounting bracket from the speed transmission

Chapters

Table of Contents

T8020 T8030 T8040