New Holland T8010 Manual page 826

Hide thumbs Also See for T8010:

Table of Contents

NOTE: Always replace damaged or heavily worn

parts. If the parts are not serviceable, the entire valve

section must be replaced.

NOTE: Always install new O-rings, backup rings and

seals during assembly.

Install new backup rings and O-rings on the on the

main poppet (1) and load check body (2). Install the

main poppet and spring (3) into the load check body

and install the cap (4).

Install the plunger in the load check. Install the load

check assembly into the valve body and tighten the

cap to a torque of 30 to 41 Nm (22 to 30 lb. ft.).

Section 35 - Hydraulic Systems, 3PT - Chapter 4

Install the spring and pressure compensated flow

control spool into the valve body. Install the plug and

tighten to a torque of 50 to 58 Nm (37 to 43 lb. ft.).

Install a washer on each end of the main spool. Be

sure that the end of the spool with the brass plug (1)

is toward the top of the valve body (the end with the

load check cap). Install the plug and tighten to a

torque of 14 to 16 Nm (10 to 12 lb. ft.).

Chapters

Table of Contents

T8020 T8030 T8040