New Holland T8010 Manual page 644

Hide thumbs Also See for T8010:

Table of Contents

Apply Loctite 515 gasket eliminator on the OD of the

seal. Install the seal over the axle shaft and into the

axle housing. The edge of the seal must be flush with

the axle housing.

IMPORTANT: Use flat bar (not shown) between

driver and seal to install seal flush with housing.

NOTE: Do not apply Loctite 515 to seal OD on the 4-

1/2-inch axle.

Remove any foreign material from the ring gear. Put

a bead of Loctite 515 gasket eliminator (1) on the

axle side of the ring gear.

Section 27 - Rear Axle - Chapter 1

Install the ring gear on the axle housing assembly.

Repeat Steps 50 through 71 for the remaining axle if

being serviced.

Chapters

Table of Contents

T8020 T8030 T8040