New Holland T8010 Manual page 476

Hide thumbs Also See for T8010:

Table of Contents

Before removing the axle, do the following:

1. Park the tractor on a hard, level surface and

place the transmission in PARK. Remove the

keys and block the front and rear of the rear

2. See information for FWD Drive Shaft Removal

and remove the drive shaft.

3. Remove the front weights and weight frame, if

4. Raise the front of the tractor and properly

support. Remove the front fenders, if equipped.

Remove the front wheels.

Tag and remove right and left steering lines (1) if

equipped, tag and remove the hydraulic differential

lock supply and return lines (not shown).

Section 25 - Four-Wheel Drive Front Axle - Chapter 6

SUSPENDED FWD AXLE

The axle position sensor is located near the center at

the left rear of the axle.

Disconnect the axle position connector.

Chapters

Table of Contents

T8020 T8030 T8040